X-Homing Does Not Reset (Printer Stays Shutoff)

[Insany109]

When my Ft-5 R2 is told to go home for Z and Y axis, it hits the respective EndStop, stops and then reconnects to the PC. When I tell my FT-5 R2 to go home for the X axis it goes home, but never reconnects to the PC. The printer stays off the entire time, until I manually move the stepper away from the X EndStop. Then the printer restarts on it's own. Has anyone had issues like this, do you have any advice on how I could resolve this?

[Insany109]

Disregard all, it was due to user error. I put the stopper upside down, once I put it facing the right direction, it worked perfectly.

[csorrows]

You are very lucky you did not burn the board. Glad you figured it out before damage was done.