I just assembled my I3 and started running it. I am amazed of how well it printed with little adjustment to the firmware, just extruder steps. The main concern I have is how load this printer is. I started out with a solidoodle press then went to the FT-5 and now this I3. The press was pretty quite, the FT-5 is very quit, unless I walk into the room I can not here it run from the hallway, then there is my I3. Prints nice for what it is, but saying its noisy is an understatement! Is this printer normally noisy or do I have something wrong, such as belts too tight, stepper voltage too high, etc? The weird thing is this is my 3rd printer and I adjusted tension and voltages as I did on my first two.
Any help would be appreciated.