SKR Pro 1.2 on an i3 2020

[Sir_Eric]

I fried my last driver for my Ramps board. I have a spare SKR Pro 1.2 from an MPCNC build, so I decided to upgrade.

All of the pre-compiled Marlin firmware I have found is for Core XY. Does anyone have a starting point for Cartesian? before I start editing the config.h file myself.

Eric

[Tin_Falcon]

Should not be that difficult
I presume since the sk pro board is 32 bit you are going with marlin 2.0.XX
There are a ton of you tube videos out there
the ender 3 is a similar set up to the 13 2020 so i would copy that profile then tweak as needed.

Hope this helps

[Sir_Eric]

Thanks. I will look at the Ender 3.
I have it moving and homing. X & Y are even scaled. Z is off a bit yet.
Haven't messed with the extruder or the heaters yet.