Hello , I have a FT-5 R1 with a BPS V3 extruder using pla @ 210c and heatbed @ 65c. I installed a Keenovo 750 watt 120v heat bed works amazing. I tested it several times works perfect. I then decided to update the Arduino to 1.8.5 and Marlin_ft5_stock_060518 firmware. The problem I have ran into has been the the shell has been absolutely perfect but once it goes to infill, whether 15% or upto 100% infill the print line seems to be lifting a fraction just high enough it does not adhere to the shell. I tryed a few different setting adjustments but to no avail. Just seeing if anyone else has ran into this problem, I am positive it is somewhere in the settings. I would send a photo and my settings but I am at work right now. I will probably reload the old firmware to see if that corrects the problem but I would really like to use the updated firmware.
Thank you, any suggestions are appreciated. I think it is something simple I am overlooking.
The infill goes from top left to bottom right that is not adhering , thank you for the replys