I'm planning some considerable upgrades for my FT-5 and I would like to make sure I understand what's going on with the Keenovo heaters.
I see 12v, 24v, 110v and 220v versions of the heaters. If I am understanding this correctly, if you swap to a 12v or 24v heater, those are powered directly from the printer PSU. If you swap to a 110v or 220v heater, those need to be powered by AC mains and are controlled via the Solid state relay and your control board.
So I can go with a 110v, 750 watt heater, run it off of mains and still change my printer PSU to 24v without any conflict, right?