Greetings. Getting back to using my FT5-2 full time. I made a circular holder in Blender, and a bushing to align the holder to a bracket. I set the ID of the bracket at 6.0mm and the OD of the aligner at 6.0mm. Prints came out great but all the dimensions are of by 0.2mm, so the ID is 5.8mm and the OD is 6.2mm. Other circular features did the same thing, example a 14mm ID hole is 13.8mm.
It appears the Repetier/Cura combo is moving the walls by 0.1mm outwards. Is there a setting that can be adjusted to get the walls back to nominal location. (I realize that using a 0mm clearance is optimistic, but I wanted to try and see how good my setup is, this were the first parts designed to fit together.)