I have received the FT-5 R2 kit in December and it came with the SKR control board and the Reprap Discount LCD Controller with the red board
The latest pre-built firmware and the supplied Marlin config and advanced .h files did not have SD support enabled
I recompiled the files with SD support enabled, and now I can browse and print from the SD card in the SD slot on the SKR board itself located in the enclosure in the back, but the SD slot on the Discount LCD Controller doesn't seem to do anything.
Is this working as intended or is there a way I can get the front SD card slot working for printing? It's a lot more convenient to access the front SD slot than it is to access inside the back enclosure