I followed the guide here to upgrade to leadscrews, my z steps needed to be set to 200 instead of 400 to get the distance right, mentioning that cause im not sure if that would indicate i did something wrong?
Anywho, after the leadscrew change i cant pritn ABS right, it prints the first layer great as normal and every layer after that seems to be smushed and pushed around by the nozzle.
example print: http://imgur.com/a/e1b6o
This is the best print ive been getting after upgrade with abs, i had to put my ext multiplier down to 7 to get it to not push plastic around, but that im pacts other areas of the print and its still worse then the quality i had pre upgrade.
For reference when i printed PLA it seemed to be fine, just ABS is giving me the issue. I spaced my nozzle using a sheet of paper and rehomed it half a dozen times to make sure an endstop isnt moving. Im not sure what to do i have some parts i need to print out of ABS but i cant get it to print right now!
bed temp is 100c nozzle is 225c (up from what i usually print at with this filament, 217c)
filament is black folgertech abs