I just installed the 713Maker FT-5 Extruder Ultralight mount, The E3D
Titan, V6 and the Nema 17 pancake motor. I used the wire diagram from https://www.youtube.com/watch?v=vG6E2lCGR-k&t=328s at 3 minutes.
The motor was doing nothing but skipping. I read a post on this forum
to switch the inter wires, so I did. Now the motor does nothing even
after I switched them back.
Did I fry something? How do I test and how can I make sure I get the wiring correct?
Jack