So, I finally found some time to get my long boxed FT-6 together and last week I started the dreaded software install.
Needless to say, I'm STILL trying to get the software installed. Arduino IDE fails consistently, and while I was able to get farther on PlatformIO, I'm still no closer to getting motors running than I was when it was in the box.
The new firmware.bin installed fine, but can't get Marlin to compile and upload. The frustration is pretty damn high and I'm a less than cheerful printer owner. (This is my 5th printer, but my first Folgertech, and so far this is the only one that I've had any trouble with getting software installed)
Anyone have some step-by-step for a guy who just wants to get his printer running?