I have been using simplify 3d for a while now, i'm definitely a fan of the software yet I need some advice. My print time estimations are incorrect by roughly 3 hours for whats stated as a 5 hour print (effectively an 8 hour print). Now I don't mind how long the print takes at all I just am not a fan of leaving it run while i'm asleep in this tiny apartment. I know this is most likely due to acceleration in the firmware as this is the conclusion I have come to after a little searching. In s3d I see no option to input the correct acceleration settings for the machine, the default profile for the ft-5 lists an x/y movement speed as 80mm/sec and a z movement speed as 16.7mm/s are these the correct settings in need of adjustment to bring my print time estimations in line? If not, are these settings appropriate for this machine? Any advice would be appreciated, If I could get estimation to within an hour of the actual print time I will be happy.