Is the voltage to the heat bed supposed to be approx. 24V?
I am only reading 21V.... and therefore unable to get the bed temperature anywhere close to 110C for ABS.
Power supply is outputting 24V... all other connectors on the board are reading 24V... only the connector to the heat bed reads 21V.
Folger support mentioned that it may be a board issue so I replaced the MKS board.... still having the same issue.
Would an issue with the bed cause this?
Trying to get a resistance reading from the board... I think I'm getting approx. 130 Ohms.
Thank you in advance for your help