So I accidentally cut a wire from my hot end thermistor, I have a replacement, but am having a few questions regarding it.
At the time being, I only have the wires twisted together and covered with some unshrunk heat shrink, only because I got to thinking, what if this happens again? Does anyone have any suggestions to make my hot end thermistor quick change? It just feels like it would be a hassle to have to solder and unsolder, etc. I had tried using insulated butt terminals, but it didn't make the mintemp go away.
For the Mintemp, is it something that when I attach the new thermistor, will it recognize it, and then reset to normal on its own? Or do I have to refresh the firmware on the printer?
Thank you in advance!