is there a good guide for setting up the firmware. step by step id10t guide so to speak? I have looked on the FB group and here. Most are for the e3d and such. None for the stock extruder.
Thanks in advance.
I believe the one on youtube has it. He goes through the configuration file. The guys name is Joe and he has a pdf of where to hook up the cables. I know I have it saved at home can't remember if it's the stock extruder though.
The publisher was Joe Mike Terranella. He did a two part video on setting up the bltouch. It was on a Prusa i3 but he does go into detail about the Marlin setup in the second video.
Video 1 is here: https://www.youtube.com/watch?v=dB6QjifoYDU
Video 2 is here: https://www.youtube.com/watch?v=OoWP5C8lSig