Well she's built, and unfortunately I can't say I had fun.
Few bolts missing, corners cut wrong, missing holes in them, square nuts don't fit, LCD doesn't fit right.
It prints, however the choke tube is already dead (melted pTFE) temps seem too low, 215C yields PLA with easy to peel away layers, common "heating failure must reset" warnings, pausing print keeps head and bed right there- destroying the piece instead of lowering the bed a bit, and finally, you cannot set the temp any hotter than 235C, even though ABS settings are 240C in pre-heat it jumps back to 235.
I don't know enough about firmware to go messing around, I did check my e-steps and fine-tuned the drivers however.
I need to contact directly, especially about the wonky corner pieces.