Hello all,
I just finished assembling FT5-R2 with BigTreeTech SKR v1.3 board and A4988 stepper drivers. When I tried to move the steppers only the X axis moved from both LCD controller and computer. I then plugged Y, Z, and extruder into the X axis one at a time and they all worked. I also plugged in each stepper driver into X axis and they all worked. After tring a few different things I saw/read on internet I noticed that when I tried to moved the Y or Z that the LCD showed them as moving but no sound or anything from the motors. X, Y and Z flash with ? and 0.
I have also tuned all the stepper drivers to around .550v. The Y axis should be higher and will adjust it later if needed.
Also, the end stops when plugged in from the kit shut off the printer when activated. I rewired one and activated it, but it does nothing now. Meaning the X motor moved both ways while being pressed.
This is my first 3D printer.