FT-5 Large Scale 3D Printer (Original & R2) Kit
Build / Setup
FT-5 Build and Setup Category
What thermistors are used on the FT-6 bed and Hotend?
What is this piece
Prints are consistently bigger by 0.2mm
2 of 3 steppers and extruder do not move
No power on new FT-5 (beginner)
FT5 R2 "Bed Assembly"
Ft-6 carage upgrade suggestion UV
Z Axis homing problems
Square nuts don't fit in the ACM [FT-5 RT]
FT-5 bed leveling
What is the stock bed heater config on FT5R2?
FT5-R2 - No Stepper Movement
Y Motors Not Moving
Stand for FT5 R2
Upgraded to 713maker full deluxe kit
40mm bolts aren't long enough to attach extruder stepper
FT-5 Stepper Motor Firmware Settings
I have issues with my Y axis
BS after BS with this printer kit
FT-5 R1 Firmware question
FT-5 Surface Print Quality
R2: Problems aligning FT2's
Single z drive question
New build, new to printing, FT-5 setup help/log
Heater bed covering ft-5?
Y axis belts coming off idlers
Frustrated and at a loss
Can't get a print started
next page →