FT-5 Large Scale 3D Printer (Original & R2) Kit
New to 3D Printing, Please help!
FT-5 FolgerTech upgrades
FT5 pulley and idler alignment
New bed springs speed leveling
FT-5 R2 bed won’t heat to temps over 100c, also my extruder keeps getting too cool during long prints
New R2 Build, Under Extrusion and binding Linear Rail
FT5 R2 Random Movements "walkabout" - Solved
Extruder cold on a new build "MINTEMP triggered system stopped Heater_ID : 0
Anticipating new build, common missteps and good first mods
FT-5 wiring and connector replacement / upgrade
FT-5 R2 won't lower bed on pause, temp capped at 235
Bondtech BMG / E3D V6 on FT-5 R2
FT-5 R2 homing problems
Think I fried my controller board
MK9 Extruder Assembly question? Issue?
Box for SSR + Heatsink
Y Grinds only when stepper motors are connected to MKS board
Driver and multiple issues
FT5 R2 Print problem
Updating stepper drivers skipping (TMC2100)
New Linear Rails for FT5 R2?
Could it be my power supply?
Arduino says 'Board unknown' about my FT-5 R2
Cooler Thermal runaway error
Endstop Location Mystery
Tool change heating position
Attaching a Computer to the FT-5: Options Needed
Assembly manual error or hardware error - hot end assy
FT 5 R2 Step 11 Belt Install Oddity
← previous page
next page →