Log In
FT-5 Large Scale 3D Printer (Original & R2) Kit
R2 Specific
New firmware for the FT-5 R2. Testers/tweekers needed (reward)
(12)
Latest manuals, updates and change logs
(4)
FT-5 R2 Specific
(1)
Extrusion Calibration Problem
(10)
Weight on top to damp vibration?
(19)
FT-5 Upgrade board, suggestions wanted!
(
2
)
(33)
TMC 2208's run hot
(4)
Hotend temp is 358ish when plugged into wall and usb
(12)
What are my options for a hotter hot end?
(12)
FT-5 lead screw upgrade, info needed
(
2
)
(25)
New to 3D Printing, Please help!
(10)
FT-5 FolgerTech upgrades
(2)
FT5 pulley and idler alignment
(3)
New bed springs speed leveling
(6)
FT-5 R2 bed won’t heat to temps over 100c, also my extruder keeps getting too cool during long prints
(6)
New R2 Build, Under Extrusion and binding Linear Rail
(4)
FT5 R2 Random Movements "walkabout" - Solved
(
2
)
(29)
Extruder cold on a new build "MINTEMP triggered system stopped Heater_ID : 0
(9)
Anticipating new build, common missteps and good first mods
(
2
)
(23)
FT-5 wiring and connector replacement / upgrade
(12)
FT-5 R2 won't lower bed on pause, temp capped at 235
(
2
)
(22)
Bondtech BMG / E3D V6 on FT-5 R2
(14)
FT-5 R2 homing problems
(3)
Think I fried my controller board
(4)
MK9 Extruder Assembly question? Issue?
(3)
Box for SSR + Heatsink
(10)
Y Grinds only when stepper motors are connected to MKS board
(12)
Driver and multiple issues
(3)
FT5 R2 Print problem
(3)
Catastrophic failure
(5)
next page →