FT-5 Large Scale 3D Printer (Original & R2) Kit
Hotends / Extruders
MINTEMP triggered, system stopped! Heater_ID: bed
FT-5 stock extruder problems
What is the Default Nozzle Diameter? Still trying to get a good print of the test cube
FT-5 MinTemp and replacement thermistor ?s
Extruder issues still?
Do heat breaks wear out?
Extruder mod for stock MK9 or E3d V6, probe and part cooling fan mounts
Leakage around nozzle into Heater block
Prusa mk2 extruder on ft5
Printing Skirts/Odd oozing from beginning of print
Blocked Extruder System
Unable to retract/reverse filament
E3D v6 Heater Block Machining Issue
FT-5 Extruder issues
Retraction in action
Hot end thermistor reading incorrect
.8 mm hardened nozzle with stock hotend?
Big Nozzles: Expert Settings for Hotend Movement
Volcano Lessons Learned
Hotend Overshoots Almost Instantly
Titan voltage settings on the board?
Extruder just clicking for/rev clickity
Twin Extruder for Bowden - Does it make sense?
Direct drive or bowden style extruder?
E3D Setup Recommendations
New Found Happiness
Extruder Not extruding
Extruder seems to run backwards, then squeezes out blob?
← previous page
next page →