Log In
FT-5 Large Scale 3D Printer (Original & R2) Kit
FT-5 Large Scale 3D Printer [READ THIS FIRST]
[
FT-5 Large Scale 3D Printer (Original & R2) Kit
]
(1)
Hitting end stop stops printer
[
R2 Specific
]
(2)
Prints are consistently bigger by 0.2mm
[
Build / Setup
]
(1)
BMG extuder and E3D V6 Volcano thoughts, months in
[
Mods / Addons
]
(5)
Bltouch firmware on FT-5 r2
[
R2 Specific
]
(12)
Talk me out of wanting 0.9° stepper motors for X and Y
(
2
)
[
Mods / Addons
]
(24)
2 of 3 steppers and extruder do not move
[
Build / Setup
]
(11)
I am Having Trouble with my new FT-5 and SKR v1.3 Firmware
[
R2 Specific
]
(5)
I cannot connect to my new FT-5 over serial port
[
R2 Specific
]
(8)
Octoprint thinks my printer is the wrong size - original script not setup properly
[
Automation / Auto-Calibration
]
(2)
X-Homing Does Not Reset (Printer Stays Shutoff)
[
Motion Systems & Components
]
(3)
No BS Heated Enclosure FT-6
[
Mods / Addons
]
(5)
Carriage direction
[
General / Other
]
(3)
Nema 17 motor question
[
Motion Systems & Components
]
(4)
Need help! Printer has gone haywire
[
R2 Specific
]
(4)
Why do my 5050 radial fans die?
[
R2 Specific
]
(6)
Duetwifi wiring
[
Mods / Addons
]
(2)
Thinking of adding an Auto bed leveling sensor
[
Mods / Addons
]
(6)
Bed Leveling sensor
[
Automation / Auto-Calibration
]
(3)
FT-5 R2 New Board Wiring - Need Help
[
Electrical / Controllers
]
(4)
FT5-1 upgrade to what?
[
Mods / Addons
]
(4)
Power Supply Failing
[
Electrical / Controllers
]
(13)
Before I buy Ft 5 r2
[
R2 Specific
]
(9)
No power on new FT-5 (beginner)
[
Build / Setup
]
(3)
[Unofficial Release] Marlin 1.1.9-FT5-R2
[
Software / Firmware
]
(5)
FT5 R2 "Bed Assembly"
[
Build / Setup
]
(3)
Ft-6 carage upgrade suggestion UV
[
Build / Setup
]
(1)
Persistent ABS failure at higher elevations in the print
(
2
)
[
R2 Specific
]
(27)
SKR v1.3 Controller + TMC 2208 + Marlin 2.0 Works!
[
Electrical / Controllers
]
(15)
Bad hot end temperature reading -15C
[
Electrical / Controllers
]
(2)
next page →